CERTON's CERTBENCH™ Automated Software, Firmware & System Testing Solutions

Visit Certon on FacebookVisit Certon on TwitterVisit Certon on LinkedIn

CERTALIGN™ Requirements Tool  |  CERTTEST™ Automated Verification  |  CERTBENCH™ Automated Testing Software & Equipment

 

Software and Hardware Requirements Solutions

 

 

<span style=

 

 

 

CERTBENCH™::RIG

 

CERTBENCH™::RIG is the complete Testing Environment solution for system level, software level, and/or hardware level verification. The CERTBENCH™::RIG integrates Certon´s CERTBENCH™::CTB application with CERTBENCH™::LRU or CERTBENCH™::PLD to verify safety critical software or hardware using the Test Cases & Procedures generated with CERTTEST™.

 

 

 

 

 

 

CERTBENCH™::CTB

 

CERTBENCH™::CTB is an application used to execute standardized verification Test Cases & Procedures generated by CERTTEST™::CertVCP in a fully automated test environment. The inputs are applied and actual results read for comparison with expected results for Pass/Fail determination and problem reports. The results report is generated in standardized template formats.

 

CERTBENCH™::LRU

 

 

Black, White, and Grey Box LRU Testing Solutions

CERTBENCH™::LRU is used to test avionics Line-Replaceable Units (LRU) at a black box level and/or grey box Level for DO-178B Verification. CERTBENCH™::LRU applies the Test Cases & Procedures file inputs and captures outputs to generated Test Results with CERTBENCH™::CTB application. CERTBENCH™::LRU provides ARINC, RF, Analog, Discrete, Serial, CAN, and MIL-STD I/O Interfaces, as well as customized proprietary formats if needed. CERTBENCH™::LRU executes fully automated tests in either black or white box environments using a single Test Cases & Procedures input file. The diagram below shows the process of CERTBENCH™::RIG utilizing CERTBENCH™::LRU to generate Test Results from the DO-178B Test Cases & Procedures that were generated with CERTTEST™.

 

Black, White, and Grey Box LRU Software Testing Solutions

 

CERTBENCH™::PLD

 

 

Black, White, and Grey Box PLD Testing Solutions

CERTBENCH™::PLD is used to test FPGA, SOC, and other Programmable Logic Devices (PLD) for DO-254 certification. CERTBENCH™::PLD hosts the PLD under test and applies Test Vectors and captures the actual results for comparison with expected results to determine Pass/Fail executing in the electrical environment. The results report is generated in standardized template formats. The diagram above shows the process of CERTBENCH™::RIG utilizing CERTBENCH™::PLD to generate Test Results from the DO-254 Test Cases & Procedures that were generated with CERTTEST™.

 

Black, White, and Grey Box PLD Hardware Testing Solutions